96
4.SETTING ITEMS (ADMIN)
3.SETTING NETWORK FUNCTIONS (Cont.)
4
Setting the IPX/SPX Protocol
You can set the IPX/SPX protocol on this equipment. The IPX/SPX protocol is usually used to communicate
with the NetWare file server through the network.
1
Press the [NETWORK] button in the
ADMIN menu.
- The NETWORK menu is displayed.
To display the ADMIN menu, see "1.ENTERING TO ADMIN MENU".
Page 78
2
Press the [IPX/SPX] button.
- The IPX/SPX screen is displayed.
3
Specify the following items as required.
- PROTOCOL — Press the [ENABLE] button to enable the IPX/
SPX protocol, or [DISABLE] button to disable the IPX/SPX
protocol.
- NCP BURST — Press the [ENABLE] button to enable the NCP
Burst Mode protocol, or [DISABLE] button to disable the NCP
Burst Mode protocol. When this is enabled, it can increase the
efficiency of communication between this equipment and
NetWare file server.
- FRAME TYPE — Press the [AUTO] button to automatically detect
the appropriate frame type, or press other specific frame type
button. If you do not know the frame type that must be used,
select the [AUTO] button.
4
Press the [ENTER] button.
- Returns you to the NETWORK menu.
To Next Page
Loading...
