2 BASIC OPERATION
24 Scan to File
If saving data in a network folder is enabled by the administrator, you can select 2 file destinations
from [MFP LOCAL], [REMOTE 1] and [REMOTE 2]. If you select [MFP LOCAL], you can specify a
network folder (REMOTE 1 or 2) as a remote destination. To set a network folder as a remote
destination, proceed to step 5.
For equipment with no hard disk installed, only either [REMOTE 1] or [REMOTE 2] can be specified
as a file destination. [MFP LOCAL] and more than one destination cannot be specified.
5
To store the scan in a network folder, press [REMOTE 1] or [REMOTE 2].
If the selected remote destination (REMOTE 1 or 2) is configured by the administrator so that you
can specify a desired network folder, the screen for setting up the remote destination is displayed.
Proceed to step 6.
If the selected remote destination (REMOTE 1 or 2) is already defined by the administrator so that
the scan is saved in a specified network folder, pressing the button does not display the screen for
specifying the file destination. In this case, you cannot change the file destination. Proceed to step
9. If you need to change the remote destination, ask your network administrator for help.
If saving data in a network folder is enabled by the administrator, you can select 2 file destinations
from [MFP LOCAL], [REMOTE 1] and [REMOTE 2].
For equipment with no hard disk installed, only either [REMOTE 1] or [REMOTE 2] can be specified
as a file destination. [MFP LOCAL] and more than one destination cannot be specified.
To Next Page
Loading...
Need help?
General
