Toshiba e-STUDIO2803AM - Pre-Service Technician Checks

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 54
4.7.8 Main charger
4.7.9 Main charger grid
(1) Open the right cover.
(2) Take off the process unit.
 P. 4-49 "4.7.1 Process unit <20L/23L/25L/
20H/23H/25H>"
 P. 4-50 "4.7.2 Process unit <23LA/23LM/
28LM/23HA/28HA>"
(3) Holding (A) of the main charger [1], slide it to
the front, and then pull out the rear side.
(4) After removing the rear side first, tilt the main
charger, and pull out the cleaning rod from
the front side.
Notes:
1. When installing/removing the main
charger, do not touch the fuser unit as it
may be hot.
2. When installing/removing the main
charger, do not touch the mesh area of
the grid.
3. When installing, insert the main charger
cleaner into the hole in front of the frame
first.
Fig. 4-139
Fig. 4-140
(1) Take off the main charger.
 P. 4-54 "4.7.8 Main charger"
(2) Release the latch of the tensioner and take
off the main charger grid [1].
Notes:
Do not touch the mesh area of the grid.
Fig. 4-141
[1]
A
A
A
A
[1]