Toshiba e-STUDIO2803AM - Exit Sensor (S3)

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 98
4.9.2 Exit sensor (S3)
3. When installing the fuser unit, hold the
positions shown in the figure.
Fig. 4-258
(1) Take off the fuser unit.
 P. 4-97 "4.9.1 Fuser unit"
(2) Open the fuser unit guide [1].
Fig. 4-259
(3) Remove 1 screw and take off the guide [2].
Fig. 4-260
[1]
[2]