e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 94
8.5.5 When the error code "F014" is displayed <23HA only>
When the error code "F014" is displayed, perform Assist Mode (3C) or Flash Memory Clear Mode (6C).
• Performing of Assist Mode (3C)
Refer to P. 5-13 "5.8 Assist Mode (3C)"
• Performing of Flash Memory Clear Mode (6C)
Refer to P. 5-29 "5.10 Flash Memory Clear Mode (6C)"
8.5.6 When "FAX Error" is displayed
[ 1 ] Phenomenon
This message appears in the equipment with the fax kit installed under the following conditions.
• No paper is loaded in the fax drawer which is specified at the fax reception.
• The fax drawer is not installed in the equipment or is installed improperly.
• The fax drawer is set to OFF and no paper is loaded in any drawers.
<Example of error message>
Fig.8-28
[ 2 ] Countermeasure
• Load the paper in the fax drawer which is specified at the fax reception.
• Install the drawer which is specified for the fax in the equipment properly.
• Select OFF for the setting of the fax drawer while paper is loaded in any of the drawers.
Remarks: Setting a fax drawer
A drawer exclusive for fax can be set for the fax reception. In this setting, only the paper in the
fax drawer is used for printing received data.
AUTO EXPOSURE
100 % A4
1
1
FAX : ERROR
TEXT / PHOTO
□FILE
FAX : ERROR
□ E-MAIL
□USB
When setting of scanning
When copying
To Next Page
Loading...
