5
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
SELF-DIAGNOSIS MODES
5 - 13
5.8 Assist Mode (3C)
5.8.1 Functions
This equipment has the Assist Mode to enable the following functions.
(1) Memory data format (CLEAR SRAM)
When the memory
*
is replaced with a new one, abnormal values may be written in the new
memory.
Memory data must be formatted with this function for such case.
* 23LA/23LM/28LM: IC10
20L/23L/25L/20H/23H/25H,23HA/28HA: IC11
Notes:
• This function is required only when a new memory is installed.
• Do not perform this function in cases other than the installation of a new memory because all
data in the memory will be deleted with this function.
(2) Memory securely erasing (ERASE SRAM SECURELY)
It overwrites all the used areas on the memory
*
with the selected data, and makes it unusable.
Immediately after selecting this function, the processing starts and is completed.
* 23LA/23LM/28LM: IC10
20L/23L/25L/20H/23H/25H,23HA/28HA: IC11
Remarks:
(3) When an F104 error has occurred, it can be removed with this function. <23LA/23LM/28LM/
23HA/28HA only>
Notes:
When the memory has been cleared in the Assist Mode (3C), check the items below and change
the value of the following codes accordingly:
• 08-3134 (Scan motor gear) <20L/23L/25L/20H/23H/25H only>
0: One-gear
1: Two-gear
• 08-9063 (Installation of the fax function)
0: Not installed
1: Installed
Though the menu includes an "SRAM" item, the machine
is actually equipped with Flash memory, not SRAM.
FIWMWARE ASSIST MODE
CLEAR SRAM
ERASE SRAM SECURELY
To Next Page
Loading...
