© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
FIRMWARE UPDATING
11 - 9
11
11.3.4 Update procedure
(1) Turn OFF the power of the equipment, and connect it and the PC with a USB cable.
(2) Turn the power ON while pressing the [4] and [9] buttons simultaneously. (Start the equipment
with the Firmware update mode)
(3) Confirm that the Firmware update mode has started from the LCD panel of the equipment.
Notes:
• Able to proceed to the next step after you check the display.
• Updating with the PC update tool should not be performed at a normal startup (power ON). Be
sure to start the equipment by turning ON the power while the [4] button and [9] button are
pressed simultaneously.
(4) Double-click the icon “UpdateFW.exe” to start up the PC update tool.
Fig.11-7
(5) Click the [Browse] button.
Fig.11-8
To Next Page
Loading...
