Toshiba e-STUDIO2803AM - Checking and Replacing the Transfer Roller

7
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
PREVENTIVE MAINTENANCE (PM)
7 - 35
7.8.5 Checking and replacing the transfer roller
1. Handling precautions
- Wear gloves to avoid touching the drum surface with your bare hands.
- Do not allow oil or fingerprints to come in contact with the surface.
- Do not hit or scratch the surface.
- Make sure you do not get any bits of thread, etc. on the surface.
- Do not allow solvent, such as thinner, to come in contact with the surface.
- Keep away from a source of heat.
2. Cleaning procedure
If bits of thread or similar adhere to the surface, remove them with gloves or a pair of tweezers. Be
careful that the roller surface is not damaged by the points of the tweezers.