Toshiba e-STUDIO2803AM - Adjustment of the Paper Feeding System

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 38
6.8 Adjustment of the Paper Feeding System
Adjustment for Drawer sideways deviation (4018).
If deviation still occurs, perform the following:
6.8.1 Sheet sideways deviation caused by paper feeding
<Procedure>
Bypass feeding
The center of the printed image shifts to the front
side.  Move the guide to the front side (Arrow
(A) direction in the lower figure).
The center of the printed image shifts to the rear
side.  Move the guide to the rear side (Arrow
(B) direction in the lower figure).
Fig.6-18
Fig.6-19
(1) Loosen the screw.
(2) Move the entire guide to the front or rear
side.
(3) Tighten the screw.
Fig.6-20
Feeding direction
Center
[Rear]
[Front]
Feeding direction
Center
[Rear]
[Front]
(A)
(B)