e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 110
(3) Remove 2 screws and take off the fuser
center thermostat (THMO1) [2].
(4) Remove 2 screws and take off the fuser front
thermostat (THMO2) [3].
Fig. 4-293
Notes:
1. Do not remove 4 screws shown in the
figure.
Fig. 4-294
2. When attaching the fuser thermostat,
place the round terminal of the cable
above the thermostat terminal, and attach
in the direction shown in the figure.
Fig. 4-295
[3]
[2]
To Next Page
Loading...
