e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 28
[E130] 1st drawer misfeeding
Classification Error content
Paper misfeeding Jam not reaching the registration sensor
Proce
dure
Check item Result Measure
Next
Step
1
Open the right cover. Is
there any paper on the
transport path?
Yes Remove the paper.
No
2
2
Is the 1st drawer feed
clutch working?
(Perform the output check
in the test mode: 03-201)
Yes
3
No • Check if the connector of the 1st drawer
feed clutch is disconnected.
• Check if any of the connectors on the MAIN
board is disconnected.
20L/23L/25L/20H/23H/25H: CN22
23LA/23LM/28LM/23HA/28HA: CN14
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the MAIN
board is short circuited or open circuited.
• Replace the 1st drawer feed clutch.
• Replace the MAIN board.
3
1st drawer feed roller
Separation roller
• Check the drawer feed roller and separation
roller.
Replace them if they are worn out.
Parts to be replaced Remark
MAIN board
Upper drawer feed clutch
Upper drawer feed roller
Separation roller
To Next Page
Loading...
