8
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
ERROR CODE AND TROUBLESHOOTING
8 - 41
[E090] Time out jam: Image data to be printed cannot be prepared.
[EAD0] Print end command time-out jam
Classification Error content
Other jam Image data to be printed cannot be prepared.
Check item Measure
Paper path • Remove the paper remained in front of the registration sensor.
• Check if the error is cleared by turning the power OFF and then
back ON.
MAIN board • Connector check
• Board check
Flash memory Check if the flash memory is correctly connected to the connector
on the MAIN board.
Replace parts Remarks
MAIN board
Flash memory
Classification Error content
Other jam Print end command time-out jam
Proce
dure
Check item Result Measure
Next
Step
1
Is the main motor
working?
(Perform the output check
in the test mode: 03-101/
151)
Yes
2
No • Replace the main motor.
2 Replacing the PC board Replace the MAIN board.
Parts to be replaced Remark
Main motor
MAIN board
To Next Page
Loading...
