e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
3 - 50
[ 3 ] General operation
[A] From power ON to standby status
• When the equipment is turned ON, if the paper empty sensor (S5) is turned OFF (L), it is judged
that there is no paper in the drawer. With the sensor (S5) being ON (H), it is judged that there is
paper in the drawer.
• If either of the sensors; registration sensor (S2) or exit sensor (S3) is ON (meaning there is paper
on the transport path) when the equipment is turned ON, it is determined that a paper jam has
occurred and no operation is enabled until the jammed paper is removed.
[B] Standby status
• After the availability of paper is checked as described above, the equipment enters the standby
state.
[C] Drawer feeding
• When the drawer feed clutch is turned ON, the driving force of the main motor (M3) is transmitted
to rotate the paper feed roller. A sheet of paper is then fed and transported to the registration
roller.
• The leading edge of the paper turns ON the registration sensor (S2), and then the paper stops at
the registration roller.
• The registration roller clutch (CLT1) is turned ON and the paper aligned by the registration roller
is transported to the transfer unit.
[D] Bypass feeding
• The bypass paper sensor (S6) detects the availability of paper.
• The drive from the main motor (M3) is transmitted to the paper feed clutch to rotate the bypass
feed clutch.
• Feeding starts and a sheet of paper is transported to the registration roller. The leading edge of
the paper turns ON the registration sensor (S2), and then the paper stops at the registration
roller.
• The registration roller clutch (CLT1) is turned ON and the paper aligned by the registration roller
is transported to the transfer unit.
To Next Page
Loading...
