Toshiba E-STUDIO2829A - Save as File Settings

5.[Administration] Tab Page
54 [Setup] Item List
 Save as File settings
You can configure the Save as file settings.
 Setting up Remote 1 and Remote 2
You can specify how users can select the network folders for Save as file destination. You can specify two network
folders; Remote 1 and Remote 2. The setting items are the same for both Remote 1 and Remote 2.
The network folder as a destination must be set to be shared by all users.
Item name Description
1 [Remote 1]/[Remote 2] Select the remote network folder you want to use.
2
Protocol
*1
Select the protocol to be used for uploading a file to the network folder.

SMB — Select this to send a file to the network folder using the SMB
protocol.
 FTP — Select this to send a file to the FTP server.
3
Server Name
*1
When you select [FTP] as the protocol, enter the FTP server name or IP
address where a scanned file will be sent. For example, to send a scanned file
to the “ftp://192.168.1.1/user/scanned” FTP folder in the FTP server, enter
“192.168.1.1” in this box. You can enter up to 64 alphanumerical characters
and symbols (- . / _ : %).
4
Port Number(Command)
*1
Enter the port number to be used for controls if you select [FTP] as the
protocol. Generally “-” is entered for the control port. When “-” is entered, the
default port number, that is set for FTP Client by an administrator, will be
used. If you do not know the default port number for FTP Client, ask your
administrator and change this option if you want to use another port number.
You can enter a value in the range from 1 to 65535 using numbers and hyphens
(-). “-” is set as the default.
5 Network Path When you select [SMB] as the protocol, enter the network path to the network
folder. For example, to specify the “users\scanned” folder in the computer
named “Client01”, enter “\\Client01\users\scanned”.
When you select [FTP] as the protocol, enter the directory in the specified FTP
server. For example, to specify the “ftp://192.168.1.1/user/scanned” FTP
folder in the FTP server, enter “user/scanned”. You can enter up to 128
alphanumerical characters, symbols (excluding " *; < > ? [ \ ] |), and spaces.
6 Login User Name Enter the log-in user name to access an SMB server, an FTP server, or a
NetWare file server, if required. When you select [FTP] as the protocol, an
anonymous log-in is assumed if you leave this box blank. You can enter up to
32 alphanumerical characters and symbols (excluding " , : ; < > [ \ ]).
7 Password Enter the password to access an SMB server or an FTP server if required. You
can enter up to 32 alphanumerical characters and symbols.
8 Retype Password Enter the same password again for a confirmation.
1
2
3
4
6
7
8
5