5.[Administration] Tab Page
[Setup] Item List 57
[Administration] Tab Page
Print Service Setting
You can configure such print services as Raw TCP Print, LPD Print, IPP Print.
Changing Print Service Setting will automatically restart the equipment.
P.57 “Setting up Raw TCP Print”
P.57 “Setting up LPD Print”
P.58 “Setting up IPP Print”
Setting up Raw TCP Print
In Raw TCP Print, you can enable or disable the Raw TCP print service.
Setting up LPD Print
In LPD Print, you can set the LPD print options to enable the LPD print service.
8 PCL Font Number Enter the font number of the internal PCL font to be used as the default font
for printing. You can check the font numbers and internal PCL fonts in the
Internal PCL Font List. Refer to the Printing Guide for the font number and
internal PCL fonts.
9 PCL Line Termination Select the type of the line termination.
10 Symbol set Select the symbol set that applies to a raw job.
11 Paper Source Select the paper source that applies to a raw job.
Item name Description
1 Enable Raw TCP Enable or disable Raw TCP print service. [Enable] is set as the default.
2 Port Number If enabling the Raw TCP, enter the Raw TCP port number for the Raw TCP
print. You can enter a value in the range from 1024 to 32767. Generally the
default value “9100” is used.
3 Enable Raw bi-directional Enable or disable Raw bi-directional communication. [Disable] is set as the
default.
Item name Description
1 Enable LPD Enable or disable LPD print service. [Enable] is set as the default.
2 Port Number Enter the port number for LPD printing. You can enter a value in the range
from 1 to 65535. Generally the default value “515” is used.
Item name Description
1
2
3
1
2
To Next Page
Loading...
