Toshiba E-STUDIO2829A - Printer Setting

5.[Administration] Tab Page
56 [Setup] Item List
 Printer Setting
This item is not available for e-STUDIO2323AM/2823AM.
 Setting up General Setting
In General Setting, you can specify the printer related options.
 Setting up Default Raw Job Setting
In Default Raw Job Setting, you can specify the default raw job setting, which applies to a raw job for which no queue
name is specified or for which a specified queue name does not exist.
Item name Description
1 LT<-->A4 / LD <-->A3 Select whether to print a document intended for one paper size can be printed
on paper of a different size. For example, you can print a document set up for
Letter size on A4 paper. When disabled, this equipment will prompt users for
the correct paper size. [Enable] is set as the default.
Item name Description
1 Raw Jobs - Duplex Printing Select whether a raw job will be printed on both sides of the paper.
2 Raw Jobs - Default Paper Size Select the default paper size that applies to a raw job.
3 Raw Jobs - Default Paper
Type
Select the default paper type that applies to a raw job.
4 Raw Jobs - Default
Orientation
Select the default orientation that applies to a raw job.
5 PCL Form Line Enter the point size of line spacing. (12.00 makes 6 lines/inch)
6 PCL Font Pitch Enter the font pitch when the selected font number represents a fixed pitch
scalable font. The font pitch indicates the number of ANK characters per inch.
10 pitch prints 10 ANK characters within an inch.
7 PCL Font Point Size Enter the font size when the selected font number represents a
proportionally spaced scalable font. The Font Size option allows you to
determine the point size (height) of the default font.
1
1
2
3
4
5
6
7
8
9
10
11