Toshiba PA912 - Page 16

Chapter 1 Introducing the PA912 Module
6F8C1259
4
System configuration example
Figure 1-1 System configuration example
Important
・
Confirm the combination condition before use the PA912 module.(See the table below). Correct combination of
module-version is needed for PA912 to work.
[Combination versions between PA912 firmware and type1]
PA912
firmware version
PA912 GSD version
nV-Tool
Version
Byte-swap
mode
type1 single system
firmware version
（
PU811
）
type1 duplex system
firmware version
（
PU811
）
TC-net I/O
loop
V1.00 TSB_0C32.gsd V4.5.1 Not Avail
V01.3A or later V01.41 or later
single
loop
only
V2.01 TSB_0C32_V2.gsd V4.6.0 or later Not Avail
V2.10 TSB_0C32.gsd V4.6.0 or later Not Avail
V2.20 or later
TSB_0C32.gsd
TSB_0C32_V2.gsd
V4.8.3 or later Avail
[Combination versions between PA912 firmware and ty
pe2]
PA912
firmware version
PA912 GSD version
nV
-
Tool
V
ersion
Byte
-
swap
mode
type2 (duplex system)
firmware version
（
PU821
）
FN812
firmware Version
OIS service
control version
TC
-
net I/O
loop
V2.20 or later
TSB_0C32.gsd
TSB_0C32_V2.gsd
V4.10.3 or later Avail V01.B0 or later V01.50 or later V04.C7 or later
single
loop
only
PU811
nV-Tool
EN811
TC-net I/O loop (electric)
SA911
RP913
PA912
PROFIBUS-DP
master station
RS
-
232C
PROFIBUS-DP
Slave 2
PROFIBUS-DP
Slave 1
TC
-
net I/O loop (optical)
PROFIBU
PROFIBUS-DP
Slave n
HMS PROFIBUS
configurator tool
(Anybus NetTool-PB)