Chapter 3 Setting
6F8C1259
3.3.3 Registering Tags
When connecting the Unified Controller type2, the tag information
registered by Tag Editor of Engineering Tool can be displayed on the face plate
and point display screen on the OIS's screen.
About Tags, refer to "Unified Controller nv series type 2 Function Manual"
(6F8C1362).
For the operation method of the Tag Editor, refer to "Unified Controller nv
series/Integrated Controller V series nV-Tool (Basic) Instruction Manual"
(6F8C1290).
Remark
•
PA912 Tag parameter I/O point variable identifier use I/O variables(IQNo) registered by
Engineering Tool.
Note
・
PA912 tag function not supported Process alarm.
To Next Page
Loading...
