3.3 Setting with the Engineering Tool
Unified Controller nv series PROFIBUS(PA912) Module Instruction Manual
47
2) Network variable registration method
Figure 3-19 Registration procedure
Note
・
When you register by a network variable registration method, nV-tool should use the version
V4.10.13 or higher.
1
Register the PA912-N to the I/O node.
2
Set the module parameters.
4
Talker block and network variable are registered.
5
Register the I/O variables of the PA912 RAS information.
3
PA912-NM is connected to a PROFIBUS network.
To Next Page
Loading...
