Unified Controller nv series PROFIBUS(PA912) Module Instruction Manual
vii
This manual is described about how to use the PA912 module.
The functions, how to install, set, and maintenance are written in this manual.
To use the module correctly, we recommend you to read “Safety Precautions” as the first
step.
The manuals related to the PA912 module are as follows.
• Unified Controller nv series Controller Unit Instruction Manual (6F8C1220)
Describes the unit hardware of the nv series controller.
•Unified Controller nv series type 1 Function Manual (6F8C1221)
Describes the functions and basic use of the nv series type 1.
•Unified Controller nv series type 2 Function Manual (6F8C1362)
Describes the functions and basic use of the nv series type 2.
• Unified Controller nv series/Integrated Controller V series Programming Instructions
(6F8C1226)
• Unified Controller nv series/Integrated Controller V series Engineering Tool 4 (Basic)
Instruction Manual (6F8C1290)
Describes how to create, debug, print, and save programs using nV-Tool.
• Unified Controller nv series/Integrated Controller V series Engineering Tool 4 (Setup)
Operation Manual (6F8C1291)
Describes how to set up nV-Tool.
• Unified Controller nv series TC-net 100 (TN8) Module Instruction Manual (6F8C1360)
Describes the TC-net 100 (TN8) module, which is common to type 1 and type 2 of the nv
series.
• High-speed Serial I/O System TC-net I/O Instruction Manual (6F8C1240)
This describes the specification, handling method and maintenance on nv series I/O and
TC-net I/O system.
Introduction
To Next Page
Loading...
