6F3B0253
22
T1-16S User’s Manual
1. System Configuration
♦ Behind the programmer port cover
PRG
H/R
V1 V0
Programmer port connector
Analog setting adjusters
(V0 and V1)
Mode control switch
(HALT / RUN)
Battery holder
Battery type: CR2032
(Optional)
A tab for battery eject
Power supply terminals:
Connect the power cable and grounding wire. The terminal screw size is M3.
See sections 4.4 and 4.5 for wiring.
Input terminals:
Connect input signal wires. The terminal screw size is M3. See section 2.4 for
details.
Output terminals:
Connect output signal wires. The terminal screw size is M3. See section 2.4 for
details.
To Next Page
Loading...
