6F3B0253
Basic Hardware and Function
33
1. System Configuration
1.9 Peripheral tools
The following peripheral tools are available for the T1-16S.
T-Series Program Development System (T-PDS)
The T-Series Program Development System (T-PDS) is a software which runs on
any IBM-PC compatible personal computers such as Toshiba’s Notebook computers.
The same T-PDS software supports on-line/off-line programming, debugging and
program documentation for all the T-Series programmable controllers T1/T1S,
T2/T2E/T2N, T3/T3H and S2T.
• User-friendly program editor includes cut & paste, address search & replace,
program block move/copy, etc.
• Group programming − part program development by multiple designers and
merging them into a complete program − enhance the software productivity.
• Powerful monitoring, I/O force and data set functions fully support your program
debugging.
• Documentation of programs with commentary makes your maintenance work
easy.
• Remote monitoring/programming via modem (radio/phone) is possible.
The table below shows the T-PDS versions that support the T1-16S.
Type Part number Versions available for
T1-16/28/40 T1-40S/T1-16S
T-PDS for Windows TMW33E1SS Ver 1.0 or later
*1)
Ver 1.2 or later
T-PDS for MS-DOS TMM33I1SS Ver 1.61 or later
*1)
Ver 2.1 or later
*1) The T1-16S can be used with these versions. However, in this case, there are
the following functional limitations.
• The program size setting is only available as 2 k. It is set to 4 k mode in the
T1-16S.
• Some of the added instructions (MAVE, DFL, HTOA, ATOH) may not be
edited/monitored. (depending on the version)
NOTE
The connection cable for the T1-16S is different from that for upper T-Series
PLCs. These cables are supplied separately.
Connection cable for T1-16S ... Type: CJ105, 5 m length
Connection cable for T2/T3 …. Type: CJ905, 5 m length
To Next Page
Loading...
