Toshiba Q9+ - Page 241

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 229
Input Function Target 3
Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Input
Function Target 3 terminal.
This setting assigns the function of the programmable Input
Function Target 3 terminal to any one of the user-selectable func-
tions listed in Table 11 on pg. 256, Table 12 on pg. 257, or Table
14 on pg. 260.
See F977 for additional information on this parameter.
Direct Access Number —
F904
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — No
Output Function Assigned
Program My Function My Function Unit 1
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the Output Function
Assigned terminal.
This setting assigns the function of the programmable Output
Function Assigned data location to one of the functions listed in
the Input Setting field of Table 11 on pg. 256.
Settings:
0 – 3099
See the My Function Instruction Manual (P/N E6581335) and
F977 for additional information on this parameter.
Direct Access Number —
F905
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — No
Input Function Target 1
Program My Function My Function Unit 2
This parameter plays a role in the setup of the My Function fea-
ture by selecting the functionality of the programmable Input
Function Target 1 terminal.
This setting assigns the function of the programmable Input
Function Target 1 terminal to any one of the user-selectable func-
tions listed in Table 11 on pg. 256, Table 12 on pg. 257, or Table
14 on pg. 260.
See F977 for additional information on this parameter.
Direct Access Number —
F906
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — No
Input Function Command 1
Program My Function My Function Unit 2
This parameter is used to assign a user-selected logical operator
to two user-selected Input Function Target variables, enable a
counter/timer function, or perform a hold/reset function.
Table 15 on pg. 262 lists the available selections. Their use and
selection requirements are described in an example at F977.
Direct Access Number —
F907
Parameter Type — Selection List
Factory Default — 0 (NOP)
Changeable During Run — No
F904 – F908