Toshiba Q9+ - Page 245

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 233
My Function Percent Data 3
Program My Function My Function Data
This parameter is used to set the trigger threshold level of the
analog signal of the My Function Percent Data 3.
The analog signal is selected using the Input Setting number
from Table 12 on page 257.
Direct Access Number —
F920
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Percent Data 4
Program My Function My Function Data
This parameter is used to set the trigger threshold level of the
analog signal of the My Function Percent Data 4.
The analog signal is selected using the Input Setting number
from Table 12 on page 257.
Direct Access Number —
F921
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Percent Data 5
Program My Function My Function Data
This parameter is used to set the trigger threshold level of the
analog signal of the My Function Percent Data 5.
The analog signal is selected using the Input Setting number
from Table 12 on page 257.
Direct Access Number —
F922
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 1
Program My Function My Function Data
This parameter is used to set the trigger threshold level of the
analog signal of the My Function Frequency Data 1.
The analog signal is selected using the Input Setting number
from Table 12 on page 257.
Direct Access Number —
F923
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — %
My Function Frequency Data 2
Program My Function My Function Data
This parameter is used to set the trigger threshold level of the
analog signal of the My Function Frequency Data 2.
The analog signal is selected using the Input Setting number
from Table 12 on page 257.
Direct Access Number —
F924
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — %
F920 – F925