Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
Motions
The unit is on standby.
↓
The unit starts to operate. The white indicator is on.
↓ After approx. three seconds,
The unit beeps three times
and continues to operate.
The white indicator flashes
for 5 seconds.
If the unit is not required to operate at this time, press [RESET]
button once more or use the remote controller to turn it off.
Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
Motions
The unit is in operation. The white indicator is on.
↓
The unit stops operating. The white indicator is turned off.
↓ After approx. three seconds,
The unit beeps three times. The white indicator flashes
for 5 seconds.
If the unit is required to operate at this time, press [RESET] button
once more or use the remote controller to turn it on.
• When the unit is standby (Not operating)
• When the unit is in operation
9-3. Auto Restart Function
This indoor unit is equipped with an automatic restarting function which allows the unit to restart operating with
the set operating conditions in the event of a power supply being accidentally shut down.
The operation will resume without warning three minutes after power is restored.
This function is set to work when shipped from the factory.
9-3-1. How to Cancel the Auto Restart Function
To cancel auto restart function, proceed as follows :
Repeat the setting procedure : the unit receives the
signal and beeps three times.
The unit will be required to be turned on with the remote controller after the main power supply is turned off.
To Next Page
Loading...
