This function is used when the circuit breaker is shared with other electrical
appliances. It limits the maximum current and power consumption to 100%,
75%, or 50% and can be implemented by POWER-SELECTION. The lower
percentage, the higher saving and also longer compressor
lifetime.
Note:
1. Press MENU button for enter menu setting and press TEMP.
button to select POWER-SEL
Press and hold
MENU
: for 5 seconds , then remote control display will
show as picture 1 for 2 seconds.
POWER-SELECTION OPERATION
6. MANUAL DEFORST OPERATION
To defrosting the heat exchanger of the outdoor unit during Heating operation
7. AIR FLOW DIRECTION
Note:
●
Do not move the louver manually by hands or others.
●
The louver may automation positioning by some operation mode.
• Due to the reason that POWER-SELECTION function limits the maximum
current, inadequate cooling or heating capacity may occur.
Blink only triangle
2. Enter POWER-SEL setting by press MENU button again.
3. Select POWER-SEL level by press TEMP. button.
100% 75% 50%
4. Confi rm POWER-SEL level by press MENU button.
5. Leave from menu setting display by select EXIT.
1
1
Press : Move the
louver in the desired vertical
direction.
2
Press : Move the
louver in the desired horizontal
direction.
3
SWING operation can be selected
from MENU button
Swing off
Vertical
(Up-Down)
Swing
Horizontal
(Left-Right)
Swing
Vertical and
Horizontal
Swing
HADA CARE
FLOW
● Vertical (Up-Down) swing
● Horizontal (Left-Right) swing
● HADA Care fl ow
To Next Page
Loading...
