Toshiba T300MV2 - General Specifications (Structure)

IF08CZ10 April, 2019 - 13 -
General Specifications (Structure)
The general specifications (structure) of the equipment are shown in the following table.
General Specifications (Structure)
Item Standard specification Additional optional
specification
Remarks
Applicable standard UL, NEMA
Ambient
conditions
Temperature
0 to +40°C for T300MV2
-20 to +50°C for MTX series
-45 to +50°C for MTX2 series
50C operation for
T300MV2 with a
derate.
Low temperature
for MTX2 is with
externally
powered heaters.
-20 to +60°C for storage
Humidity Max 95%, no condensation
(except MTX series when heaters are
powered)
A
t no time should
the drive be
subjected to
conditions that
would allow
condensation to
form on the
components.
Altitude 1000 m Max. above sea level Higher altitudes
with a derate and
and special
magnetics.
Installation
location
Indoors
Outdoors for MTX series
Vibration 10 to 60 Hz, 0.5 G or less
Corrosive
factors
Hydrogen Sulfide (H
2
S)  0.001 PPM
This is a list of
corrosive agents
know to attack
the drive
components.
Other agents
may also have
adverse effects
on the drive.
Sulfur Dioxide (SO
2
)  0.05 PPM
Chlorine gas (Cl
2
)  0.1 PPM
Ammonia gas (NH
3
)  0.1 PPM
Nitrogen Dioxide (NO
2
)  0.02 PPM
Nitrogen Oxide (NOx)  0.02 PPM
Ozone (O
3
)  0.002 PPM
Hydrochloric acid mist (HCl
1
)  0.1 mg/m
3
Paint color Cubicle
surface
ANSI 61 Gray (T300MV2)
White (MTX series)
Consult factory for
optional colors
Cubicle structure Front maintenance (T300MV2)
MTX requires front, back, and side access
Cubicle protective
structure
NEMA 1, Forced ventilated (T300MV2)
N3R (MTX series)
With channel base
Air filter Front mounted (T300MV2)