Toshiba T300MV2 - Frame 1 Drive Lifting and Assembly (ContD)

IF08CZ10 April, 2019 - 59 -
DRIVE INSTALLATION DRAWINGS (cont’d)
Frame 1 drive lifting and assembly (cont’d)
LIFTING EYES
FOR JOINING CABINETS
1/2 INCH HOLES
T
R
A
N
S
F
O
R
M
E
R
A
S
S
E
M
B
L
Y
I
N
V
E
R
T
E
R
A
S
S
E
M
B
L
Y
G
R
O
U
N
D
B
U
S
I
N
T
E
R
C
O
N
N
E
C
T
B
E
H
IN
D
F
I
L
T
E
R
S
F
A
N
A
S
S
E
M
B
L
Y
AND DC BUS CABLES
CONTROL WIRE CONNECTOR
TO MOVE THE SECTIONS USE A FORKLIFT OF ADEQUATE CAPACITY
FAN CONTROL / POWER WIRE CONNECTOR
AND MOUNTING HOLES
LIFT FROM THE SLOTS IN THE CHANNEL BASE ON THE TRANSFORMER SECTION.
THE INVERTER SECTION IS SHIPPED WITH 4x4 POSTS ATTACHED TO BOTTOM.
MAKE SURE THE FORKS EXTEND ENTIRELY THROUGH THE SECTION.
NOTE: OVERHEAD LIFTING PROVISIONS ARE PROVIDED ONLY FOR THE INVERTER SECTION.
AFTER THE SECTIONS ARE IN PLACE BOLT TOGETHER WITH WITH 1/2" HARDWARE.
THEN INSTALL AND WIRE THE FAN ASSEMBLIES.
CONNECT THE DC BUS CABLES TO THE MODULES AND PLUG IN THE CONTROL CONNECTOR
ASSEMBLE THE GROUND BUS SPLICE.
TOW MOTOR SLOTS