Toshiba TE2 Series - Fault Mode Operations

TE2 Series Digital Solid State Soft Starter User Manual 27 | Page
 5.4.3.a Changing a Value by Increments
Although it may be easier to shift the cursor position, it is also
possible to increase or decrease values by pressing the UP or
DOWN arrow keys successively. This will change the Function
value by the incremental amount associated with that Function. The
Function List shows increment values for each Function.
Example 2: Figure 5.4.3.a
Changing a Function’s Value by Increments
[0000.] Indicates that Phase A is drawing no current
(unit is in Off mode).
Press the [Fn] key
[F001] Indicates that this is Function 001 (Motor FLA).
The right most digit (1) is flashing, indicating this
is the digit that you will alter (cursor position).
Press the UP Arrow key twice
to increase this digit value to 3
[F003] Indicates that this is Function 003
(OL Class During Start).
Press [READ/ENTER] key
to view the F003 value
[0010] Indicates that the programmed OL is Class 10
during the Start Mode. Cursor flashing on right
most digit.
Press the UP Arrow key
to increase this digit value
[0015] Indicates that you have increased the Function
value by the increment assigned to it, a value of 5
in this case.
Press the UP Arrow key again
to increase this digit value
[0020] Indicates that you have again increased the
Function value by the increment assigned to it.
Press [READ/ENTER] key
to store the new value
[End] The word “End” will flash briefly to indicate that
the new value has been entered and accepted.
After flashing once, the display will revert to
showing the Function number.
5.4.4 Storing the Altered Value of a Function
Once the desired value is displayed, press the [READ/ENTER] key.
This stores the value in memory. The readout momentarily displays
[End] and then returns to the function code.
Caution!
If the Fn key is pressed or power is lost before the [READ/ENTER]
key is pressed, the TE2 Series Starter will not store the selected
value in memory.
Display
Pre ss
Key...
Shows...
Means...
Phase A
Current
Function #1
Displayed
Previous Setting
of Function #3
Value Increased
by 1 Increment
Value Increased
by 1 Increment
0000.
F0 0 1
0010
0015
0020
End
Value Accepted
(flashes once)
Return to
Function # Display
Figure 5.4.3.a:
Changing a Function Value by Increments
Example 2: Setting the OL Curve
During Start
Change from Class 10 to Class 20
F003
New Value of
First Digit
F003
x2
Fn
READ
ENTER
READ
ENTER