Toshiba THP700-IP - Tool Air Piping

DUST- & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
STE85336
– 27 –
4.2 Tool Air Piping
The robot is provided four (4) air lines for the tool.
The outer diameter of the air pipelines is 6 mm. Fig. 4.6 shows the tool air piping.
The air control unit (oiler, regulator with gage and filter) and solenoid valves should be
provided by the user.
The air tube is identified by the number and color. At piping, make sure that each tube
is connected properly, referring to the below-mentioned.
1 : Red 2 : White 3 : Blue 4 : Yellow
Air joint pitches of the panel
Fig. 4.6 Tool air piping
Wiring panel
Details
4×
φ
6 air tube
(Hand air joint 4×M5)
Det
4
ails
×
φ
6 quick-operated
j
oint for hand
1
3
4
2
1
3
4
2