DUST- & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
STE85336
– 39 –
6. Cleaning Robot Body
To clean and wash the robot body, be sure to use a neutral detergent. Use a soft
sponge and waste cloth, and take careful precautions not to cut or scratch the robot
body.
To wash the robot body with water, strictly observe the IP class in terms of water. Be
sure to water the robot body while conducting air purge.
!
DANGER
• Before cleaning the robot body, be sure to turn off the controller power and
remove the power plug. Otherwise, you will get an electric shock or the robot
will malfunction, which is very dangerous.
• After the cleaning, completely wipe out the water.
!
CAUTION
• Be sure to use a neutral detergent to clean and wash the robot body. If a
detergent (such as chlorine detergent and acid detergent) other than the
neutral detergent is used, the paint may deteriorate, or the cover or bellows
may be damaged.
• Be sure to water the robot body during air purging. Unless air purge is
executed, the dust- and drip-proof performance is damaged to cause entry of
water or dust.
To Next Page
Loading...
