DUST- & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
When mounting the cover, apply the liquid gasket to the area shown in Fig. 5.7
above. Also, apply the Loctite adhesives to all set bolts.
!
CAUTION
• When using the cutter, take careful precautions not to cut the gasket body.
• DO NOT peel off the liquid gasket between the cover and gasket.
Otherwise, the dust- and drip-proof performance is damaged to cause entry
of water or dust.
• Under some circumstances, the gasket may be separated from the cover.
When this happens, apply the liquid gasket to between the cover and gasket
at the time of cover mounting.
• Be sure to attach the gasket and apply the liquid gasket. Also, be sure to
coat the Loctite adhesives to all set bolts. Otherwise, the dust- and
drip-proof performance is damaged to cause entry of water or dust.
• Be sure to replace the gasket before it is damaged. Damaged gasket
causes the deterioration of the dust- and drip-proof performance.
STE85336
– 38 –
To Next Page
Loading...
