14/68
3.3. General safety instructions
• Do not operate the product unless you are of age.
• The person responsible for the use of the product must make sure that all of the
safety rules in force in the country of its use are applied, to guarantee that the
equipment is used in conformity with the use for which it is destined and to avoid
any dangerous situation for the user.
• The solid tyre press must be installed and maintained in accordance with all the
applicable national and local codes. A power disconnect switch must be located
near the equipment. Check the technical data for voltage and phase requirements.
• Use the solid tyre press for the purpose for which it is designed. Do not carry out
any other work on it.
• Do not operate the solid tyre press if any components are damaged or missing.
• Immediately stop the solid tyre press in case of hose or line breaks, defective
cylinders or other components.
• The operator should wear safety glasses, hearing protection, safety shoes and
safety gloves when using or maintaining the solid tyre press.
• To prevent burns, fire and explosion, regularly check all pipes, hoses and
tubes. Never bend or crush the pipes! Have damaged pipes or hoses repaired
immediately.
• For safety reasons, the solid tyre press has a 4-way plug as a safety feature and
only fits into an earthed socket. If you cannot insert the plug into the socket,
youmay have an older, ungrounded socket. Contact an electrician to have the
outlet replaced. Do not use an adapter to ground the outlet.
• Read this manual carefully. Make sure that the manual is available at all times and
store it in a dry, dark place near the unit.
• Do not overload the solid tyre press in any way.
• Do not carry out repairs or maintenance work while the solid tyre press is running.
First cut off the power supply.
• Do not insert any objects into rotating parts such as cooling fans and/or electric
motors.
• The solid tyre press is a source of power. Through intensive use, incorrect
connection or overloading, parts can become hot. Avoid touching hot components
at all times.
• Do not wear loose clothing so that the clothing cannot get caught in the solid tyre
press.
• Protect the power cord from being walked on or becoming pinched. If the power
cord is damaged or frayed, replace it immediately.
• If an extension cord or receptacle is used, ensure that the total amperage required
for all equipment on the extension is less than the rating of the extension.
• Only people who work with the solid tyre press may be in the vicinity of the device.
Other people must keep a minimum distance of 3 metres.
• Pneumatic tyres cannot be fitted using the solid tyre press.
To Next Page
Loading...