17/68
2. Lowering
1. When lowering the solid tyre press, first return the mast of the forklift to its upright
position. Do this gently and slowly so that the solid tyre press cannot tip over.
2. Lower the forks until the solid tyre press is on the ground again
4.2. Storage
• Make sure that the solid tyre press is located on a flat surface.
• Make sure that there is no direct sunlight on the solid tyre press.
• Do not cover the solid tyre press so that it can cool down sufficiently.
• Do not place the solid tyre press in a humid area or a place where splashes of any kind of
liquid can hit it.
• The solid tyre press should be stored in a space between –20°C and 60°C.
– This solid tyre press uses hydraulic oil, extreme temperatures may lead to a change in
the oil’s viscosity.
• Keep the solid tyre press away from areas where sparks are generated.
• Provide good ventilation.
• Place protection around the solid tyre press so that no one can drive into or collide with it.
• Place a fire extinguisher close by.
• Install smoke detectors nearby.
• Do not place any objects on top of the solid tyre press. Keep a clean working space.
To Next Page
Loading...