Total Source 161TA6945 - Assembly and Installation; Packing List; Safety Instructions for the Assembly and Installation of the Product

18/68
5. ASSEMBLY AND INSTALLATION
5.1. Packing list
161TA6944
Description Amount Reference
Solid tyre press 1 161TA6944
Reduction table 1 166TA5332
Operating manual 1 166TA9027
161TA6945
Description Amount Reference
Solid tyre press 1 161TA6945
Reduction table 1 166TA5332
Operating manual 1 166TA9027
The necessary tools to assemble and disassemble tyres are not supplied with the solid tyre
press. All necessary tools can be found in chapter11C.
5.2. Safety instructions for the assembly and installation of the product
The operator should wear safety glasses, hearing protection, safety shoes and safety
gloves when using or maintaining the solid tyre press.
To prevent burns, fire and explosion, regularly check all pipes, hoses and tubes.
Never bend or crush the pipes! Have damaged pipes or hoses repaired immediately.
• If an extension cord or receptacle is used, ensure that the total amperage required
for all equipment on the extension is less than the rating of the extension.
• Protect the power cord from being walked on or becoming pinched. If the power
cord is damaged or frayed, replace it immediately.
• Do not install the solid tyre press near heat sources such as radiators or air ducts.
• Do not install the solid tyre press in a place subjected to direct sunlight, excessive
dust, mechanical vibrations or shocks.
• Ensure a safe, level, stable and load-bearing surface on which to place the solid
tyre press.
• Place the solid tyre press in such a place that inspection and maintenance can be
carried out in a reasonable manner afterwards.
• Provide additional lighting if visibility is restricted in the work area.
• If an extension cord or receptacle is used, ensure that the total amperage required
for all equipment on the extension is less than the rating of the extension.
• Place the solid tyre press in an open and well-ventilated area.
• To prevent fire or shock hazard, do not expose the solid tyre press to rain or
moisture.
• Make sure that the solid tyre press is installed as instructed in this manual and in
accordance with any applicable national or local norm.
• Only people who work with the solid tyre press may be in the vicinity of the device.
Other people must keep a minimum distance of 3metres.