20/68
5.5. Securing the product to the ground
1. Place the machine on the ground. When doing so, leave the forks temporarily in place.
2. Using a pencil, mark the spots on the ground where you are going to drill by marking the
drill holes.
3. Move the forklift back so that the machine is out of the way.
4. Place your drill, with the attached drill bit, in a straight vertical position.
5. Drill the holes in the ground to a maximum depth of 100mm.
6. Place the expansion plugs in each hole and push them into the hole. If you cannot push
the expansion plugs in manually, give them a short but gentle tap with the hammer so
that they completely enter the drilled hole.
7. Reposition the solid tyre press. Make sure that the machine is back in the same place so
that the drill holes and the holes in the machine line up.
8. Now take the impact tool and the wedge bolts.
9. Place a wedge bolt into the impact tool.
10. Make sure the wedge bolt is at a straight vertical angle.
11. Secure the machine to the ground.
To Next Page
Loading...