37/68
8.2. Maintenance schedule
Task 2H D W M 6M Y
1. Daily maintenance check
2. Cleaning
3. Check of electrical wiring
4. Check of hydraulic lines
5. Check of the hydraulic oil level
6. Inspection of identification lights
7. Check of the fuses
8. Check that the solid tyre press does not come off the
ground
9. Check for hydraulic oil leaks
10. Check of the inside of the electric motor
2H: every 2hours, D: daily, W: weekly, M: monthly, 6M: every 6months, Y: yearly
8.3. Maintenance instructions
1. Daily maintenance check
If you check the solid tyre press before each use, you can limit wear to a minimum:
• Make sure that the instruction manual is complete, legible and available for reference.
• Check the entire machine for damage, corrosion or cracks in structural components
before each use.
Can be done by the user.
2. Cleaning
To remove excessive dust, you can use a non-electrostatic cloth.
For more persistent dirt, use a mild soap such as REF131TA5500 with fresh, lukewarm
water.
Do not use excessive water on the electrical components. Use a damp cloth for this purpose.
Never use petrol, white spirit, or other harsh detergents to clean the device.
Do not use a high-pressure cleaner to clean the device. Doing so may irreversibly damage
components.
Can be done by the user.
3. Check of electrical wiring
Check the electric cables for cracks, fissures or other weathering.
Also check that the cable is still firmly attached to the plug.
If you notice that one or more cables are weathered or broken, replace them immediately.
Use only original spare parts or spare parts of equal quality.
Check can be done by the user.
Repairs should be done by a qualified technician. Contact your dealer!
To Next Page
Loading...