38/68
4. Check of hydraulic lines
Check the hydraulic hoses for cracks, fissures or other weathering.
In addition, check that the hose clamps are still tight and that no oil is leaking.
If you notice that one or more hoses are weathered or broken, replace them immediately.
Use only original spare parts or spare parts of equal quality.
Check can be done by the user.
Repairs should be done by a qualified technician. Contact your dealer!
5. Check of the hydraulic oil level
The hydraulic oil level must be between the red and blue marks on
the oil pressure gauge.
The oil level must be sufficient at all times. If the oil level drops
below the lowest mark, use hydraulic oil with viscosity index 10
(ISO 6743/4 HM, Dension HF0).
Use hydraulic oil REF141TA3215 for a correct and optimum result.
Checking and replenishment can be done by the user.
6. Inspection of identification lights
Check that all the identification lights are still on. If a light functions incorrectly or is not
working, the fuse may have blown.
Check can be done by the user.
Repairs should be done by a qualified technician. Contact your dealer!
7. Check of the fuses
Check the fuses to prevent them from blowing. If you notice that they are wearing out,
replace them.
Check can be done by the user.
Repairs should be done by a qualified technician. Contact your dealer!
8. Check that the solid tyre press does not come off the ground
Check that the solid tyre press is still properly attached to the floor.
If you notice that this is not the case, tighten the mounting bolts.
Check and implementation can be carried out by the user.
To Next Page
Loading...