15/68
4. TRANSPORT AND STORAGE
The operator should wear safety glasses, hearing protection, safety shoes and safety
gloves when using or maintaining the solid tyre press.
• If lifting equipment is used when installing the solid tyre press, the operators
must also be familiar with the operating procedures of the lifting equipment used.
Readthe manual before using the lifting equipment.
• The solid tyre press may only be lifted with the fork pockets intended for this
purpose.
• Make sure that nobody can be on top of, next to or under the solid tyre press during
the transport and/or lifting of the solid tyre press in connection with possible tilting
or falling.
• When moving the solid tyre press by lorry or van, make sure that the solid tyre
Press is secured with some tension straps, for example. Make sure that they are
not stretched over the control panel.
• Observe the weight of the solid tyre press.
• Do not install the solid tyre press in a place subjected to direct sunlight, excessive
dust, mechanical vibrations or shocks.
4.1. Transport
We recommend that once the solid tyre press has been delivered, it should not be
moved by a truck or van. Immediately move the solid tyre press to its designated
place with a forklift truck.
If you do want to use a truck or van, place the solid tyre press against the wall of the loading
space and secure the solid tyre press with straps that can hold its weight.
Jolting caused by the wheels catching on uneven surfaces can cause physical strain
and personal injury.
When using a forklift, make sure that the forklift truck can lift the solid tyre press.
See the type plate for the correct weight.
To Next Page
Loading...