16/68
1. Lifting
1. Make sure the solid tyre press is on a flat and stable surface.
2. Stand in front of the solid tyre press with the forklift.
3. Place the forks at the same height as the fork pockets.
4. Insert the forks in the fork pockets.
5. Drive the forklift truck as far forward as possible so that the solid tyre press hits the ends
of the forks.
6. Once the solid tyre press is on the forks, raise it about 200mm off the ground.
7. Tilt the mast of the forklift slightly backwards so that it is at an angle of 95degrees.
8. Drive at a slow pace, do not make abrupt movements and do not brake suddenly.
Correct pick-up Incorrect pick-up
200 mm
To Next Page
Loading...