TOX PRESSOTECHNIK CEP400T - Page 104

Troubleshooting
104
TOX_Manual_Process-monitoring-unit_CEP400T_en
Fault Cause Analysis Measure
Number of
pieces
reached Error
'Counter value
reached'
Tool lifetime
has been
reached
Status signal Number of
pieces reached is set
Check tool for wear and
replace if necessary; re-
set the lifetime counter.
Warning limit
in succession
Error "Warning
limit exceeded'
The preset
warning limit
has been ex-
ceeded n
times
Status signal Warning
limit in succession is set
Check tool for wear and
replace if necessary; re-
set the counter by quit-
ting the measurement
menu.