TOX PRESSOTECHNIK CEP400T - DMS Signals

Technical data
40
TOX_Manual_Process-monitoring-unit_CEP400T_en
4.11 DMS signals
Force measuring via DMS force transducer. The input is selected in menu
''Configuration\Force sensor configuration''(see Configuring the force sen-
sor, Page 69).
Description Value
Nominal force adjustable
see Setting Nominal Force / Nominal Dis-
tance Parameters.
Nominal stroke
A/D converter 16 bit ≙ 65536 steps
Nominal load of resolution 65536 steps, 1 step (bit) = nominal load /
65536
Gain error ±0.5 %
Max. sampling rate 2000Hz (0.5ms)
Bridge voltage 5V
Characteristic value Adjustable
Adjustment value
The entry 'Nominal force' must match the nominal value of the force sensor
used. See the data sheet of the force sensor.
4.11.1 Built-in version: pin assignment, analog standard signals
One Sub-D 15-pole female connector each (designation analog I/O) is
available for 4 measurement channels.
Pin Type
Input/Output
Analog signal
1 I Force signal 0-10 V, channel 1 / 5 / 9
3 I Ground force signal, channel 1 / 5 / 9
4 i Force signal 0-10 V, channel 2 / 6 / 10
6 I Ground force signal, channel 2 / 6 / 10
7 o Analog output 1: tare +10 V
8 o Ground
9 I Force signal 0-10 V, channel 3 / 7 / 11
10 I Ground force signal, channel 3 / 7 / 11
11 I Force signal 0-10 V, channel 4 / 8 / 12
12 I Ground force signal, channel 4 / 8 / 12
13 o Analog output 2: 0-10 V
14 o Ground
15 o +10 V sensor supply