About this product
TOX_Manual_Process-monitoring-unit_CEP400T_en
19
3.3 Function description
3.3.1 Process monitoring
The process monitoring system compares the maximum force during a
clinching process with the target values that are set in the device. Depend-
ing on the result of the measurement, a good/bad message is issued both
on the internal display as well as the external interfaces provided.
3.3.2 Force monitoring
Measurement of force:
For tongs, the force is generally recorded via a screw sensor.
For presses, the force is recorded via a force sensor behind the die or
the punch (monitoring of the maximum value)
3.3.3 Force measurement
The process monitoring system compares the maximum measured force
with the set maximum and minimum limit values.
MAX limit value
Peak value of
poining process
MIN limit value
Monitoring control dimension 'X' by precision limit caliper
Pressforce
control by
load cell
Fig.1 Force measurement
To Next Page
Loading...