Software
TOX_Manual_Process-monitoring-unit_CEP400T_en
61
8.3.5 Icons
Display/control panel Function
Menu The Configuration menu opens.
Error reset Resets an error.
This button only appears in the
event of an error.
Firmware version Reads the firmware version.
Click on this button to read more
information.
Measure OK The last measurement was OK.
Measurement NOK Last measurement was not OK.
At least one evaluation criteria
was violated (envelope curve,
window).
Warning limit The measurement is OK, but the
set warning limit has been
reached.
Measure active The measurement is in
progress.
Device ready to measure The process monitoring system
is ready to start a measurement.
Device not ready to mea-
sure
The process monitoring system
is not ready to start a measure-
ment.
Fault Process monitoring signals a
fault.
The exact cause of the error is
highlighted in red at the top of
the screen.
To Next Page
Loading...