Software
TOX_Manual_Process-monitoring-unit_CEP400T_en
89
ü The user is logged in with a suitable user level. The necessary write
permissions are available.
è Tap on the desired language to select it.
u The selected language will be available immediately
Configure communication parameters
In the ''Supplement / Communication parameters'' menu the user can:
Change the IP address
Change the field bus parameters
Enable the remote access
Change the IP address
In menu ''Supplement \ Configuration parameter\IP address'' the Ethernet
IP address, the subnet mask and the default gateway can be changed.
Defining IP address via the DHCP protocol
ü The user is logged in with a suitable user level. The necessary write
permissions are available.
1. Tap on DHCP checkbox.
2. Tap the Accept button.
3. Restart the device.
Defining IP Address by entering a Value
ü The user is logged in with a suitable user level. The necessary write
permissions are available.
1. Tap on the first input field of the IP address group, enter the first three
digits of the IP address to be used and press the OK button to confirm.
w The numerical keyboard opens.
2. Repeat the procedure for all input fields in the IP address group.
3. Repeat point 2 and 3 to enter the Subnet mask and Default Gateway.
4. Tap the Accept button.
5. Restart the device.
To Next Page
Loading...