TP-Link AC1750 - Port Forwarding, DMZ, and UPnP

Archer C8
AC1750 Wireless Dual Band Gigabit Router
- 68 -
Figure 5-49 NAT Boost
5.10 Forwarding
Figure 5-50 The Forwarding menu
There are four submenus under the Forwarding menu: Virtual Servers, Port Triggering, DMZ
and UPnP. Click any of them, and you will be able to configure the corresponding function.
5.10.1 Virtual Servers
Choose menu “Advanced
→
Forwarding
→
Virtual Servers”, and then you can view and add
virtual servers in the next screen shown in
Figure 5-51. Virtual servers can be used for setting up
public services on your LAN. A virtual server is defined as a service port, and all requests from
Internet to this service port will be redirected to the computer specified by the server IP. Any PC
that was used for a virtual server must have a static or reserved IP address because its IP
address may change when using the DHCP function. If you want the Virtual Servers
configuration take effect, please make sure the NAT is enabled.
Figure 5-51 Virtual Servers