27
4.2 AP Firmware Upgrade
Choose the menu AP Control > AP Firmware Upgrade > AP Firmware Upgrade to load the
following page.
With it enabled, import the correct firmwares and set the starting upgrade time. The
connected APs will start to upgrade at the specified time. If it is disabled, the APs that
haven’t started upgrading will not be upgraded.
Figure 4-5 AP Firmware Upgrade
AP Model Displays the AP model.
Hardware Version Displays the current hardware version.
Firmware Version Displays the imported firmware version.
Upgrade Starting Time After the upgrade file has been imported successfully, specify the upgrade
starting time. With upgrade enabled, the APs of this model will automatically
upgrade using the upgrade file.
Upgrade Process Displays the upgrade process. The format is X/Y/Z, which means there are Z
APs of this model in the system, with Y APs waiting to upgrade and X APs have
upgraded successfully. Click the numbers to check each AP's upgrade status.
Upgrade Failure Displays the number of APs which failed to upgrade. Click the number to check
the detailed log information.
To Next Page
Loading...
