77
• Dynamic
If you choose Dynamic as the IP address mode, make sure that there is a reachable
DHCP server on your network and the DHCP sever is properly configured to assign IP
address and the other network parameters to the AP.
For network stability, you can also configure the fallback IP parameters for the AP:
Fallback IP With the fallback IP configured, if the AP fails to get an IP
address from a DHCP server within 10 seconds, the fallback IP
will work as the IP address of the AP. After that, however, the AP
will keep trying to obtain an IP address from the DHCP server
until it succeeds.
DHCP Fallback IP Specify a fallback IP address for the AP. Make sure that this IP
address is not being used by any other device in the same LAN.
The default DHCP fallback IP is 192.168.0.254.
DHCP Fallback IP MASK Specify the network mask of the fallback IP. The default DHCP
fallback IP mask is 255.255.255.0.
DHCP Fallback Gateway Specify the network gateway.
• Static
If you choose Static as the IP address mode, you need to manually specify an IP
address and the related network parameters for the AP. Make sure that the specified IP
address is not being used by any other device in the same LAN.
To Next Page
Loading...
