29
Chapter 4 Congure the Router in Wireless Router Mode
I want to:
Deny or allow specific wireless client devices to access my network by their MAC
addresses.
For example, you want the wireless client A with the MAC address 00:0A:EB:B0:00:0B
and the wireless client B with the MAC address 00:0A:EB:00:07:5F to access the router,
but other wireless clients cannot access the router
How can I do that?
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Wireless > Wireless MAC Filtering.
3. Click Enable to enable the Wireless MAC Filtering function.
4. Select Allow the stations specified by any enabled entries in the list to access as
the filtering rule.
5. Delete all or disable all entries if there are any entries already.
6. Click Add New and fill in the blank.
1 ) Enter the MAC address 00:0A:EB:B0:00:0B/00:0A:EB:00:07:5F in the MAC
Address field.
2 ) Enter wireless client A/B in the Description field.
3 ) Select Enabled in the Status drop-down list.
4 ) Click Save and click Back.
7. The configured filtering rules should be listed as the picture shows below.
To Next Page
Loading...
