60
Chapter 4 Congure the Router in Wireless Router Mode
2. Enter the address or domain of the NTP Server I or NTP Server II.
3. Click Get GMT to get time from the internet if you have connected to the internet.
• To set Daylight Saving Time:
1. Select Enable DaylightSaving.
2. Select the start time from the drop-down list in the Start field.
3. Select the end time from the drop-down list in the End field.
4. Click Save.
Note:
This setting will be used for some time-based functions such as firewall. You must specify your time zone once you log
in to the router successfully; otherwise, time-based functions will not take effect.
4. 18. 2. LED Control
The LED Control allows you to turn on or off the LEDs on your device according to a
specific time schedule.
1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to System Tools > LED Control.
3. Enable the Night Mode.
4. Set the LED Off Time and click Save.
4. 18. 3. Feedback
This page allows you to send your questions or suggestions to us, so that we can
resolve your issues and keep improving product features to give you a better network
experience. For technical problems, it is recommended to attach the configuration file
or system log of the device to help us investigate your case.
To Next Page
Loading...
